Leaking & Broken Taps Auckland

← Back to Emergency Plumber

A dripping tap might seem like a minor annoyance, but left unfixed it wastes a staggering amount of water and money. A single dripping tap can waste over 20,000 litres of water per year -- that is water you are paying for and sending straight down the drain. Whether you are in Howick, Mt Eden, Takapuna, or Manukau, Water and Gas Worx can get your taps sorted quickly with fair, upfront pricing.

Types of Taps We Repair and Replace

We work with every type of tap found in Auckland homes and commercial properties:

Mixer taps -- single lever controlling both hot and cold, the most common tap in modern kitchens and bathrooms across Auckland
Pillar taps -- separate hot and cold taps, typically found in older Auckland homes built before the 1990s
Monobloc taps -- a single-unit mixer mounted through one hole, popular for kitchen sinks and laundry tubs
Garden and hose taps -- outdoor taps that take a beating from sun and weather, often the first to develop leaks
Wall-mounted taps -- commonly used in laundries, commercial kitchens, and some bathroom setups

Common Causes of Tap Leaks

Understanding why your tap is leaking helps determine whether a repair or replacement is the better option:

Worn washers -- the most common cause of a dripping tap, especially in older pillar taps. A quick, inexpensive fix in most cases.
Damaged O-rings -- these rubber seals sit around the tap spindle and degrade over time, causing leaks around the base of the handle.
Ceramic disc failure -- modern mixer taps use ceramic discs instead of washers. When these crack or wear, the tap drips or becomes difficult to turn off fully.
Cartridge failure -- single-lever mixer taps rely on a cartridge mechanism. A faulty cartridge causes dripping, poor temperature control, or stiff operation.
Corrosion and sediment -- Auckland's water supply can cause mineral build-up inside tap bodies over time, leading to restricted flow or internal leaks.
High water pressure -- mains pressure properties in areas like Remuera, Ellerslie, and the North Shore can put extra strain on tap components, accelerating wear.

Repair or Replace?

When a Repair Makes Sense

If the tap body is in good condition and the issue is a worn washer, O-ring, or replaceable cartridge, a repair is usually the most cost-effective option. Most tap repairs take under an hour and the parts are inexpensive.

When Replacement Is the Better Option

If the tap is corroded, the body is cracked, parts are no longer available, or you are upgrading your kitchen or bathroom, a new tap is the way to go. We supply and install quality tap brands including Methven, Moen, Grohe, and Felton -- all suited to New Zealand water conditions and pressure ratings.

Low Pressure vs Mains Pressure

Auckland has a mix of low-pressure (gravity-fed from a header tank) and mains-pressure properties. The type of tap you need depends on your water pressure setup. Installing a mains-pressure tap on a low-pressure system will result in poor flow, while some taps are rated for mains pressure only. We check your pressure and recommend the right tap for your property every time.

Many older homes in suburbs like Grey Lynn, Ponsonby, and Mt Albert still run low-pressure systems. If you are unsure what pressure your property runs, we can test it during a service call and advise on the best tap options.

Kitchen and Bathroom Tap Upgrades

Replacing old taps is one of the simplest upgrades you can make to a kitchen or bathroom. Modern mixer taps offer better water efficiency, easier temperature control, and a cleaner look. If you are renovating in Pakuranga, Henderson, Albany, or anywhere across Auckland, we can help you choose and install taps that suit your space and budget.

We also handle full vanity and sink replacements where tap holes need to be reconfigured. Whether it is a single tap swap or part of a larger renovation, we get it done right the first time.

Tap Brands We Work With

We repair and install taps from all major brands available in New Zealand, including Methven, Felton, Grohe, Moen, Dorf, and Caroma. We can also source specialty taps for commercial or heritage applications. If your existing tap needs a specific part, we will track it down.